3SX Automotive Services - Performance Upgrade and Tuning Specialists

SuperFlow AutoDyn 880
AWD Chassis Dynamometer

On February 6, 2007, we FINALLY strapped a car onto the dyno for the first time! We've had SuperFlow reps around for in-house training and setup to make sure everything is hooked up and running properly.

We have been hard at work to get the dyno ready to rumble and it is now fully operational with the room setup and we have all of the necessary equipment, accessory sensors, tie downs, fans and cooling, tire ramps, etc. Our Grand Opening was March 17, and our technicians have completed AEM training as well as had SuperFlow manufacturer's representatives in house to ensure we are familiar with every aspect of the dyno. All this training ensures that you are getting only the BEST technicians and service for your vehicle and we are able to tune it to maximize and optimize its performance!!

Call 704-784-DRAG (3724) to schedule your dyno tuning.

SuperFlow AutoDyn 880 AWD
* 1500+ HP (traction limited)
* 200mph top speed
* Dual axle with four 42" diameter roller drums
* Direct drive dual eddy-current absorbers
* Front & rear rollers are connected, accomodates modern vehicles with speed, traction, and ABS sensors
* Independently measure torque for each roll set (front/rear power split)
* AWD Wheel bases from 92" to 118"
* Longer 2WD vehicles can run using only the drive axle
* Track widths from 40" inner to 84" outer

3SX AWD Dyno Rates & Packages

3SX Performance is excited to invite you to take advantage of our AWD Dyno, capable of running almost any sports car or coupe (and trucks) on the road! We offer various packages to suit your power and tuning needs.

3 Pulls WITH Wideband O2 $75	3SX straps down your vehicle and runs your car through 3 "pulls" and presents you with a graphic horsepower and torque curve printout.
Tune Your Own Car WITH Wideband $125 per Hour	3SX straps down your vehicle and runs your car. Between runs you can make tuning adjustments based on previous runs. Includes Wideband O2 logging on output graphs.
3SX Tunes Your Car $149 per Hour We have the tools, knowledge, and experience to tune any setup. This includes but is not limited to Domestic/Import, Forced Induction/All Motor/Nitrous, Fuel injected/Carburetor.	3SX straps down your vehicle, runs your car and tunes it for optimal performance. You will be provided with first-run and last-run output graphs. Includes Wideband O2 logging on printouts.
Log Additional Sensors: $15 each	Also log boost or oil temperature.
MAFT Tune $149/hr	3SX straps down your vehicle and tunes your MAFT system to maximize your car's power output.
Apexi SAFC Tune $149/hr	3SX straps down your vehicle and tunes your Apexi SAFC ( I / II / NEO ) system to maximize your car's power output.
DSMLINK Tune $149/hr	3SX straps down your vehicle and tunes your DSMLINK system to maximize your car's power output. .
COBB Protune $149/hr Subaru/Mazda/Mitsubishi Nissan/Infinity	3SX straps down your vehicle and tunes your COBB AP system to maximize your car's power output. NOTE: You will need to drop off your car for this tune.
Open Port Tune $149/hr Subaru/Mitsubishi	3SX straps down your vehicle and tunes your system to maximize your car's power output. NOTE: You will need to drop off your car for this tune.
AEM Tune $149/hr Our technicians are AEM Factory Trained!	3SX straps down your vehicle and tunes your AEM to maximize your car's power output. NOTE: You will need to drop off your car for this tune - it may take up to 2 weeks to complete.
"Dyno Day"	Call for full-day club or individual package rates.

Speedometer Testing - $75	3SX will strap your car on the dyno and test your vehicle to determine if your speedometer gauge is accurate, and report the variance if there is any. NOTE: This is NOT speedometer calibration, only testing the accuracy of your speedometer versus the actual physical speed your vehicles travels (e.g., with the dyno rolling at 50 mph - which IS calibrated - your speedometer reads XX mph).

Our dyno can accomodate vehicles with wheelbases of 92" thru 118". Longer or shorter 2WD vehicles (such as some trucks, legends race cars, etc.) can be run by using only the drive axle on the roller drums.

Vehicle owner MUST sign a waiver prior to 3SX operating the vehicle on the dyno. 3SX is not responsible for any vehicle damage resulting from the car being on the dyno.

Call 704-784-DRAG (3724) for scheduling

Below are some pictures of the dyno in action and the control room with viewing area. Click each picture to load it larger in a separate window.

Pictures of our Dyno installation.

Click to see some pictures from our installation project.